OpenCPI community, Geon Technologies has completed OpenCPI support for the Zynq UltraScale+ along with baseline OpenCPI Board Support Packages for the ZCU102 and ZCU111 (hardware acceleration only). Here are the relevant repositories: - OpenCPI fork and branch: https://github.com/Geontech/opencpi/tree/release_1.4_zynq_ultra - OpenCPI Board Support Packages for ZCU102/ZCU111: https://github.com/Geontech/bsp_zcu1xx - OpenCPI Xilinx 2018.2 Software Platform: https://github.com/Geontech/sw_xilinx18_2 - Yocto Project Manifest which uses the OpenCPI layer: https://github.com/Geontech/opencpi-manifest - OpenCPI Yocto layer: https://github.com/Geontech/meta-opencpi For now, the OpenCPI framework changes are on the Geontech GitHub page, but we will be putting in a pull request to hopefully have these changes merged into mainline OpenCPI. The ZCU102/ZCU111 BSPs are in the bsp_zcu1xx repository along with documentation for getting started with these boards and with this custom release of OpenCPI. The working OpenCPI Software Platform for these boards is in the sw_xilinx_18_2 repository and requires installation of Xilinx Vivado 2018.2. For all three of these repositories the relevant branch is "release_1.4_zynq_ultra". An OpenCPI SD card can be generated using Yocto with the help of the opencpi-manifest repository which uses the meta-opencpi Yocto layer. All of this and more is explained in the ZCU102/ZCU111 Getting Started Guides: - https://github.com/Geontech/bsp_zcu1xx/blob/release_1.4_zynq_ultra/pdfs/ZCU102_Getting_Started_Guide.pdf - https://github.com/Geontech/bsp_zcu1xx/blob/release_1.4_zynq_ultra/pdfs/ZCU111_Getting_Started_Guide.pdf We plan to provide RPMs and SD card images to the community as soon as possible, but for now the processes for building this custom release of the framework from source, building the SD card, and even building RPMs from source are all documented in these Getting Started Guides. In the meantime, for the simplest development process, you can reach out to Geon directly to obtain RPMs and SD card images. You can reach me at dbanks@geontech.com. The Reading List at https://github.com/Geontech/bsp_zcu1xx will provide more information and direct you to the above mentioned documents as well as ANGRYVIPER's relevant documentation. Please reach out if you have any questions at all. Regards, David Banks dbanks@geontech.com Geon Technologies, LLC